![]() ![]() To attach the control unit to the printer base the mount for it has to lock into the grooves on the sides of the base.Īgain using an included Allen wrench, rotate the screws until the tabs align with the grooves then tighten them to hold the mount securely. The four gantry bolts can be tightened using the included large Allen wrench.Īfter the gantry is attached, the control unit needs to be mounted and linked to the printer base. It takes a little bit of patience and adjustments to get them aligned, but they eventually fall into place. It’s important to make sure that the two holes for the gantry bolts on either side of the base align perfectly with the holes on the gantry. The most important initial task is affixing the Max Neo’s gantry.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |